Lightweight Universal Headshell with Precision Cartridge Adjustment
The Audio-Technica AT-LT10 Universal Headshell provides a lightweight, rigid mounting platform for compatible 4-pin phono cartridges using the standard ½-inch mounting system. Its die-cast aluminum body is designed to minimize unnecessary vibration while maintaining the strength required for accurate cartridge alignment and stable vinyl playback.
Elongated cartridge-mounting slots allow precise positioning for proper overhang and effective tonearm length, while oxygen-free copper lead wires provide a high-quality electrical connection between the cartridge and tonearm. A slip-resistant finger lift makes manual cueing easier, and compatibility with cartridges both with and without threaded inserts makes the AT-LT10 a flexible choice for turntable upgrades and multiple-cartridge setups.
Highlights & Benefits
-
Universal ½-Inch Cartridge Mount — Designed for compatible 4-pin phono cartridges using the standard ½-inch mounting configuration.
-
Die-Cast Aluminum Body — Lightweight, rigid construction helps minimize unwanted vibration while providing a stable cartridge mounting platform.
-
Adjustable Cartridge Positioning — Elongated mounting slots allow precise cartridge placement for proper overhang and effective tonearm length.
-
OFC Lead Wires — Oxygen-free copper cartridge leads provide a clean electrical connection between the cartridge pins and headshell contacts.
-
Slip-Resistant Finger Lift — Provides secure control when manually cueing the tonearm and positioning the stylus on a record.
Technology & Design
Universal ½-Inch Architecture — The AT-LT10 accepts standard 4-pin cartridges with or without built-in threaded inserts, providing broad compatibility with Audio-Technica and other cartridge brands.
Elongated Through-Holes — The adjustable mounting slots allow the cartridge to slide forward or backward during setup, making precise overhang alignment possible on compatible tonearms.
Oxygen-Free Copper Wiring — Factory-installed OFC lead wires carry the low-level cartridge signal from the four cartridge pins to the headshell connector.
Low-Mass Aluminum Construction — The die-cast body weighs approximately 10 grams without lead wires, helping maintain manageable effective tonearm mass while providing a rigid foundation for the cartridge.
FAQ — Audio-Technica AT-LT10
What cartridges fit the AT-LT10?
The AT-LT10 is designed for standard ½-inch-mount, 4-pin phono cartridges. Audio-Technica specifies compatibility with cartridges both with and without threaded mounting inserts.
Can cartridge overhang be adjusted?
Yes. The headshell uses elongated mounting slots that allow the cartridge to move forward or backward so proper overhang and effective tonearm length can be established during cartridge alignment.
How much does the AT-LT10 weigh?
Audio-Technica specifies a weight of approximately 10.0 grams excluding the lead wires. When supplied on turntables such as the AT-LP7X, Audio-Technica specifies approximately 10.7 grams including lead wires.
Does the AT-LT10 include cartridge mounting hardware?
Yes. Audio-Technica includes two 10mm M2.6 screws, two 8mm M2.6 screws and two plastic washers for cartridge installation.
Why Buy From Us
- Authorized Audio-Technica Dealer
- 5% Reward Points on Every Purchase
- Expert Cartridge, Headshell and Tonearm Matching Assistance
- Free Shipping Nationwide
